The Ramp tool enables you to select two locations on your Landscape and create a flat ramp between the two points, with a falloff you specify for the sides.
Using the Ramp Tool
-
In the Landscape toolbar, in the Sculpt tab, select the Ramp tool.
-
In the viewport, Left-click and drag or simply Left-click in two different places on your Landscape to mark the beginning and end points of the ramp.
If you change your mind about adding a ramp after starting to set the beginning and end points, you can click Reset to clear them.
-
Select either marker and adjust its position. In this case, it has been moved along the Z-axis above the Landscape surface.
-
When you are satisfied with the position, click the Add Ramp button in the Tool Settings to create the ramp.
Now you have a ramp that has been sculpted into your heightmap.
Tool Settings
![]() |
![]() |
---|---|
Property | Description |
---|---|
Ramp Width | Sets the width of the ramp. |
Side Falloff | Sets the edge falloff on the sides of the ramp where it merges inot the rest of the landscape. This falloff gives a softness to the edge flow on these sides. A setting of 0 means no falloff; a setting of 1 means all falloff and no flat surface for the ramp. |